Project Name
Project Number
UEPH Complex
Statement of Work
26 November 2001
Providing residential type clothes washer and dryer in each living unit is a HQ approved option.
If the design district is considering use for this project, coordination with user and installation
facilities engineer (DPW) is essential. Carefully weigh the benefits and drawbacks of providing
laundry appliances in each unit. Appliances shall be Energy Star compliant. Note, also, that for
optimum performance and minimum maintenance and fire hazard, dryers should exhaust to the
exterior with as little ductwork as possible; this puts additional design parameters on the
arrangement of the floor plan of the units
Base: resilient cove base
Walls: painted gypsum wallboard or painted veneer plaster
Wall area between countertop and wall cabinets: ceramic tile, plastic laminate, or color coordinated
back wall shield (if unitized kitchen is used)
Ceiling: painted gypsum wallboard, painted veneer plaster, or painted underside of precast
concrete structural floor planks
2-2.1.3.5 Other requirements: At wall areas around dining table provide chair rail or similar
wall protection to protect walls from chair and table impact. It is desirable, but not required, to
have exterior window in room. Window shall not be located adjacent to an exterior corridor or
breezeway. Door between public corridor and service area (entry door into module) shall have
mortise dormitory function (F13) lockset.
2-2.1.4
Bathroom. Provide minimum of one bathroom per module.
2-2.1.4.1 Function: Bathing and toilet facilities for either occupant; storage for both occupants'
bath articles.
2-2.1.4.2 Adjacency requirements: Adjacent to service area or interior hallway. Provide
600mm [2'-0"] wide door between bathroom and service area or hallway.
2-2.1.4.3 Furnishings/Fixtures/Equipment (FFE): Lavatory shall be minimum 475mm x 475mm
[19" x 19"] self-rimming vitreous china, or cast-filled acrylic or solid surfacing material integrally
molded to countertop. Provide chrome-plated washerless faucet with pop-up drain (refer to
Chapter 8). Countertop shall be minimum 900mm [3'-0"] wide cast-filled acrylic, acrylic solid
surfacing material, or plastic laminate with integrally molded, 100mm high coved backsplash.
Provide 102mm high side splash at side walls. Provide plastic laminate surfaced vanity base
cabinet with hinged door(s) and minimum two 225mm [9"] wide drawers. Provide 6mm [1/4"]
thick x minimum 1050mm [3'-6"] high mirror glass, full width of vanity countertop, with wall
mounted vanity light fixture above mirror (refer to Chapter 9). Provide one recessed medicine
cabinet, two soap holders, two toothbrush/tumbler holders. Provide floor mounted toilet with full
seat and seat cover (lid). Provide bathtub, chrome-plated brass showerhead, and anti-scald
single-handle mixing valve (refer to Chapter 8). Provide two minimum 600mm [2'-0"] long towel
bars mounted on walls outside tub/shower enclosure, two wall mounted soap holders in the
tub/shower, and one door mounted robe hook with two hooks. Provide wall mounted retractable
clothesline across tub/shower. Provide mildew-resistant vinyl shower curtain with stainless
steel curtain hooks and chrome-plated brass shower curtain rod. Provide single roll toilet tissue
dispenser.
Floor: ceramic tile
SOW-7