CEMP-E
TI 810-32
10 January 2002
STAINLESS STEEL BAND (TYPE 201
STAINLESS STEEL, 1/2 " WIDE, 0.030"
TRANSITION BOOT CLAMPED TO
THICK) WITH CORROSION RESISTANT
INSULATION JACKET ABOVE &
BUCKLES
SLEEVE BELOW (SEE NOTES)
SLEEVE GROUTED INTO MANHOLE
TOP (BEVEL EXPOSED END OF
SLEEVE)
18"min
CONCRETE VAULT TOP
6"
2"
2"
INSUL. & JACKETING
STEAM OR CONDENSATE LINES
A
B
C
A=OUTSIDE PIPE DIA.
B=OUTSIDE INSUL.&JACKET DIA.*
C=MIN. SLEEVE INSIDE DIA.=B+4
* SEE SPEC. FOR INSULATION THICKNESS
NOTES:
1. TRANSITION BOOT (LINER) SHALL BE:
- 25 MIL THICKNESS (MIN)
- E.P.D.M. TYPE MEMBRANE
- COMPATIBLE AT HIGH (220^ F) AND LOW
(-40^ F) TEMPERATURES
- RESISTANT TO ULTRAVIOLET LIGHT
DEGRADATION
2. LINER SEAM SHALL PROVIDE 2" MINIMUM OF OVERLAP.
USE SOLVENT CEMENT AS APPROVED BY LINER MANUFACTURER.
VALVE MANHOLE TOP PENETRATION
NO SCALE
Figure 7-8. Valve Manhole Top Penetration Detail.
7-10
Previous Page
