MIL-HDBK-1024/1
6.2.5.3
400-Hz Power.
Provide 400-Hz power for the NTDS/ACDS in accordance
with par. 2.5.9.
6.2.6
Security. The FACSFAC is normally located within restricted areas
which meet the minimum security measures for external security. When the
facility is located within a restricted area of a lower level of security or
is located remote and outside of an established restricted area. Provide
additional measures to meet the minimum security requirements for the level of
security assigned to the facility. Security at the main entrance usually
requires a single entry point with visitor control. Remote locks, video
cameras, card readers, and/or key pads may be required by COMNISCOM as
components of the IDS. The level of security and the designer's
responsibility for particular security elements will be designated in the
IDSEP. Refer to par. 2.6. Provide the following:
a)
Electronic cipher door locks at access points to operations
room.
b) Exterior doors in the operations, the NTDS/ACDS,
equipment/maintenance, and mechanical/electrical rooms with no access hardware
on the outside.
c)
CCTV.
d) Security fencing and guard post for facilities located outside
the secure area of the Naval installation.
e) Personnel identification, visitor check-in, and control system
to control ingress and egress.
6.2.7
Additional Design Criteria.
Refer to Section 2 for facility design
requirements not addressed above.
6.3
Joint Control Facility (JCF)
6.3.1
Function. The JCF is a high density (air traffic) facility which
collocates approach control responsibilities for two or more air stations or a
combination of an approach control facility and a FACSFAC or Range Operations
Center (ROC) under one roof. The JCF normally operates continuously.
6.3.2
Location. Locate the JCF adjacent to the air operations building
when siting criteria permits. An air traffic control tower may be sited with
the JCF.
101
Previous Page
