UFC 4-150-07
19 June 2001
Placement:
a. Install reinforcing wire fabric to ensure the laps project no more
than 20 mm (4/5 inch) from surface being covered.
b. Usually start work at bottom and move up; may follow the tide
down.
c. Fix the profile.
d. Fill out the area to the original face.
e. Apply each coat at least 5 cm (2 inches) thick. The final coat should
be at least 13 mm (1/2 inch) thick.
f. Ensure that rebound material is not trapped in corners or edges.
g. Ensure reinforcing bars are properly encased.
Curing: Use wet burlap for 7 days or use a curing compound.
7-14
Previous Page
