UFC 3-535-01
17 November 2005
contain a minimum of six lights. When the line of runway edge lights are located at the
maximum distance of 3 meters (10 feet) from the pavement edge of the runway, an
additional in-pavement light will be installed in each group for a total of 7 lights in each
group. The threshold lights should be controlled with the runway edge light circuit.
8-2.4
Taxiway Lights and Signs
Taxiway lighting and associated taxiway guidance signs will be in accordance with the
criteria stated in Chapter 9.
8-2.5
Approach Lights
Approach light systems, when considered necessary, should be installed in accordance
with the criteria cited in Chapter 7 for VFR or IFR conditions as appropriate.
8-2.6
Heliport/Helipad Identification Beacon
8-2.6.1
Purpose
A heliport beacon should be provided when long range guidance is considered
necessary and not provided by other means, or helipad identification is difficult due to
surrounding lights.
8-2.6.2
Configuration
The beacon must contain a colored sequence of lights, double peak white flash, and a
single peak green and yellow. The flash must be 10 to 15 sequences of flashes per
minute. The time between each color should be one-third of the total sequence time.
The beacon should not be installed within 1.6 kilometers (1 mile) of any existing airport
beacon or other helipad area.
8-2.6.3
Construction
The beacon should be visible for a distance of 1.6 kilometers (1 mile) in 1.6 kilometer (1
mile) VMC visibility daylight, and 4.8 kilometers (3 miles) in 4.8 kilometer (3 miles) VMC
at night, both from an altitude of 915 meters (3,000 feet) above ground level. The
beacon should be mounted a minimum of 15 meters (50 feet) above the helipad
surface. Where a control tower or control area is utilized the beacon should be no closer
than 122 meters (400 feet) nor further than 1,067 meters (3,500 feet) from that area,
and not located between the control tower and the helipad. The beacon will be installed
so that the base is not less than 4.6 meters (15 feet) above the floor of the control tower
or operations room.
8-2.6.4
Luminous Features
The main beam of the light should be aimed a minimum of 5 degrees above the
horizontal and should not produce light below the horizontal in excess of 1,000
candelas. Light shields may be used in order to reduce the intensity below the
horizontal.
118